Black plate (252,1)
Model "S51-D" EDITED: 2008/ 3/ 26
phone under the following conditions:
—
Your vehicle is outside of the tele-
phone service area.
—
Your vehicle is in an area where it is
difficult to receive radio waves; such
as in a tunnel, in an underground
parking garage, behind a tall build-
ing or in a mountainous area.
—
Your cellular phone is locked in order
not to be dialed.
.
When the radio wave condition is not
ideal or ambient sound is too loud, it
may be difficult to hear the other
person
’
s voice during a call.
.
Immediately after the ignition switch is
pushed to the ON position, it may be
impossible to receive a call for a short
period of time.
.
Do not place the cellular phone in an
area surrounded by metal or far away
from the in-vehicle phone module to
prevent tone quality degradation and
wireless connection disruption.
.
While a cellular phone is connected
through the Bluetooth
®
wireless con-
nection, the battery power of the
cellular phone may discharge quicker
than usual.
.
If the Bluetooth
®
Hands-Free Phone
System seems to be malfunctioning,
please visit www.infiniti.com/bluetooth
for troubleshooting help.
.
Some cellular phones or other devices
may cause interference or a buzzing
noise to come from the audio system
speakers. Storing the device in a
different location may reduce or elim-
inate the noise.
.
Refer to the cellular phone Owner
’
s
Manual regarding the telephone pairing
procedure specific to your phone,
battery charging, cellular phone anten-
na, etc.
.
The antenna display on the monitor will
not coincide with the antenna display
of some cellular phones.
.
Keep the interior of the vehicle as quiet
as possible to hear the caller
’
s voice
clearly as well as to minimize its
echoes.
.
If reception between callers is unclear,
adjusting the incoming or outgoing call
volume may improve the clarity.
REGULATORY INFORMATION
FCC Regulatory information
—
CAUTION: To maintain compliance with
FCC
’
s RF exposure guidelines, use only
the supplied antenna. Unauthorized
antenna, modification, or attachments
could damage the transmitter and may
violate FCC regulations.
—
Operation is subject to the following
two conditions:
1) this device may not cause interference
and
2) this device must accept any interfer-
ence, including interference that may
cause undesired operation of the de-
vice
IC Regulatory information
—
Operation is subject to the following
two conditions: (1) this device may not
cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
—
This Class B digital apparatus meets all
requirements of the Canadian Interfer-
ence-Causing Equipment Regulations.
4-86
Monitor, climate, audio, phone and voice recognition systems