![background image](/i/line-6/137387/line-6-xd-v70l-xd-v70-xd-v70hs/h/line-6-xd-v70l-xd-v70-xd-v70hs-016.png)
XD-V70 Beltpack Transmitter
4•2
RF Power (“Power”)
The second push to the “SELECT” button will advance the user to the Transmit Power
high/low select page. If the anticipated range usage falls short of about 100 feet, it is
recommended to switch the Tx power range to “low” as it will conserve battery life and
reduce RF interference to other devices. If sufficient range is not possible in low power
mode then the user should switch up to high power mode. Press the “VALUE” button to
toggle between the two power modes.
Transmitter Name (“Name”)
The default for the name feature is off. Pressing the “VALUE” button and selecting “On”,
advances the user to the naming screen. Here you may scroll through the alpha-numerical
list by pressing the “VALUE” button and assign up to 6 characters (A-Z, blank space, -,
and 0-9 are available) to name the transmitter. Pressing “SELECT” advances the user
to the next character to the right. This name will be transmitted to the receiver, where
it will be displayed in the receiver’s LCD window allowing easy match-up of transmitter
to receiver. When the name feature is off, the receiver will show the model name of the
transmitter (e.g., “TBP12” for the handheld microphone).
Exit Edit Mode
Pressing and holding the “SELECT” button stores the performed edits into the microphone’s
memory. The edits are remembered when powering down and then turning back on, and
when the batteries are replaced. They are also remembered should the batteries die during
a performance. If no actions are performed for 10 seconds, “time out” will occur and the
transmitter will automatically exit edit mode (and save any edits that had been made).
Mute Function
Press the “MUTE” button for approximately one second to initiate the mute function.
Press again to return to active mode. The LCD screen will remain illuminated while in
Mute mode.
Lockout Switch
After the transmitter is powered up, simultaneously press and hold the “SELECT”
and “VALUE” buttons to lock the beltpack transmitter from unauthorized editing by
performers. In Lockout mode no changes can be made to the user interface, including
channel selection, muting or power on/off. The LCD screen will show “LOCKED” and a
small lock icon will appear in the bottom left of the screen. To return to active, again press
and hold simultaneously the “SELECT” and “VALUE” buttons.