XD-V70 Receiver
2•4
best results, no more than 6 receivers should be connected to a pair of antennas.The last
receiver in the chain must be terminated by connecting the supplied “BNC terminators”
to the last “A & B Outs”. It is highly recommended to use a 50 ohm low leakage type of
antenna cable such as LMR-195 for these connections (such as the ones supplied with the
XDV-70).
3. Terminating
The supplied “BNC terminators” should be installed on any unused “A & B Outs” for
maximum performance.
Audio Outputs
The XD-V70 receiver is equipped with both a balanced three pin XLR connector and
an unbalanced ¼” output. These are “mic level” and are basically “unity” compared to
the input microphone used. Treat the XLR connector just the way you would treat the
output jack of a wired microphone. The ¼” is convenient should you wish to plug into an
instrument amplifier or an unbalanced input on a mixer.
As different mic models are selected on the handheld transmitter the output level will
vary just as it would if you were to “hot-swap” the wired versions of these mics .
219.93
44.47