Chapter 13 Spanning Tree Protocol
ES3500 Series User’s Guide
130
13.4 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see
for more information on
RSTP. Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Figure 64
Advanced Application > Spanning Tree Protocol > RSTP
The following table describes the labels in this screen.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Table 33
Advanced Application > Spanning Tree Protocol > Configuration (continued)
LABEL
DESCRIPTION
Table 34
Advanced Application > Spanning Tree Protocol > RSTP
LABEL
DESCRIPTION
Status
Click Status to display the RSTP Status screen (see
).
Active
Select this check box to activate RSTP. Clear this checkbox to disable RSTP.
Note: You must also activate
Rapid Spanning Tree
in the
Advanced Application
>
Spanning Tree Protocol
>
Configuration
screen to enable RSTP on the Switch.