Chapter 45 Configure Clone
ES3500 Series User’s Guide
334
The following table describes the labels in this screen.
Table 148
Management > Configure Clone
LABEL
DESCRIPTION
Source/
Destination
Port
Enter the source port under the Source label. This port’s attributes are copied.
Enter the destination port or ports under the Destination label. These are the ports which
are going to have the same attributes as the source port. You can enter individual ports
separated by a comma or a range of ports by using a dash.
Example:
•
2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
•
2-6 indicates that ports 2 through 6 are the destination ports.
Basic Setting
Select which port settings (you configured in the Basic Setting menus) should be copied to
the destination port(s).
Advanced
Application
Select which port settings (you configured in the Advanced Application menus) should be
copied to the destination ports.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.