Chapter 39 Access Control
ES3500 Series User’s Guide
301
39.3.4 Configuring SNMP
Click Management > Access Control > SNMP to view the screen as shown. Use this screen to
configure your SNMP settings.
Figure 180
Management > Access Control > SNMP
The following table describes the labels in this screen.
rmon
RmonRisingAlarm
1.3.6.1.2.1.16.0.1
This trap is sent when a variable goes
over the RMON "rising" threshold.
RmonFallingAlarm
1.3.6.1.2.1.16.0.2
This trap is sent when the variable falls
below the RMON "falling" threshold.
cfm
dot1agCfmFaultAlarm
1.3.111.2.802.1.1.8.0.1
The trap is sent when the Switch
detects a connectivity fault.
Table 131
SNMP Switch Traps (continued)
OPTION
OBJECT LABEL
OBJECT ID
DESCRIPTION
Table 132
Management > Access Control > SNMP
LABEL
DESCRIPTION
General Setting
Use this section to specify the SNMP version and community (password) values.
Version
Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or
both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP version 1.
Get Community
Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or
lower.