![background image](/i/zyxel/152077/zyxel-gs1920-48/h/zyxel-gs1920-48-176.png)
Chapter 23 Multicast
GS1920 Series User’s Guide
176
23.5.1
MLD Snooping-proxy
Click the MLD Snooping-proxy link in the Advanced Application > Multicast > IPv6 Multicast
screen to display the screen as shown. See Section 23.1 on page 165 for more information on
multicasting.
Figure 130
Advanced Application > Multicast > IPv6Multicast > MLD Snooping-proxy
The following tabel describes the fields in the above screen.
23.5.2
MLD Snooping-proxy VLAN
Click the VLAN link in the Advanced Application > Multicast > IPv6 Multicast > MLD
Snooping-proxy screen to display the screen as shown.
Table 76
Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL
DESCRIPTION
MLD Snooping-proxy
Use these settings to configure MLD snooping-proxy.
Active
Select Active to enable MLD snooping-proxy on the Switch to minimize MLD
control messages and allow better network performance.
802.1p Priority
Select a priority level (0-7) to which the Switch changes the priority in outgoing
MLD messages.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.