57
57
16.3 Using the Virtual Keyboard
16.3 Using the Virtual Keyboard
It is recommended that you create folders and rename fi les or folders from your computer when it is connected
to the AV 700 TV. The computer keyboard is much easier to use. However, at times when you are not near your
computer and need to enter text directly with the AV 700 TV (ex: renaming a fi le or creating a new folder). For
this, the virtual keyboard screen will appear.
The new text that you are typing
Cursor
Press ENTER to enter the
highlighted
key/letter.
Change keyboard between upper case and lower case
Backspace button
Clear the entered text
Confi rmation to use the entered text.
Hold down on the LEFT or RIGHT buttons to move the cursor within the entry line.
58
58
1
17
7
Connecting/Disconnecting the AV 700 TV to/from your PC
Connecting/Disconnecting the AV 700 TV to/from your PC
Note that when the AV 700 TV is connected to a computer, it will use more energy than usual. Your battery power will be
consumed at a higher rate than normal. It is normal that the AV 700 TV will get hot. If the AV 700 TV looses power while
connected to your computer you could damage your directory structure and/or loose data. Thus, you should always use
the AC adapter when connected to your computer. Be careful to understand the disconnection procedure also since
disconnecting incorrectly can lead to data loss or computer/AV 700 TV freeze up. The AV 700 TV is not compatible with
Windows
®
NT, Windows
®
95, or Windows
®
98. While connected to your computer, the AV 700 TV buttons are blocked
and are no longer functional.
17.1 USB Connection Type (‘Hard Drive’ or ‘Windows Device’)
17.1 USB Connection Type (‘Hard Drive’ or ‘Windows Device’)
Your device comes confi gured as a Windows
®
Device and will be immediately recognized by your
computer if you are running Windows
®
XP (with Service Pack 1 minimum) and Windows Media
®
Player
10. If you have another version of Windows
®
, not sure what version of Windows
®
XP you have, or if
you are using a Macintosh
®
, then you will need to change the USB (Universal Serial Bus) Port setting
on the AV 700 TV. You will do this by going to the setup action icon and then to
System
and
USB Port
and change it to ‘
Hard Drive
’.
17.2 Connecting the AV 700 TV
17.2 Connecting
the
AV
700
TV
Connection order: See the sections below for your particular computer’s operating system.
1) Connect the power adapter to the AV 700 TV.
2) With your computer running, plug the USB cable into your computer.
3) With the AV 700 TV off, plug in the other end of the USB cable to the AV 700 TV USB Device port.
4) Turn on the AV 700 TV. (If your computer asks to install a new driver for the new hardware, then you must
unplug it and change the USB Port to Hard Drive.)