![background image](/i/dell/156534/dell-1250c/h/dell-1250c-079.png)
Operator Panel
77
Printing a Device Settings Page
Press and hold the
(
Start)
button when the Ready/Data indicator lights
(ready status) until the Ready/Data indicator blinks.
Resetting Defaults
After executing this function and rebooting the printer, all the menu
parameters are reset to their default values.
1
Turn off the printer.
2
Open the rear cover.
3
While holding down the
(Start)
and the
(Cancel)
buttons at the
same time, turn on the printer.
4
After the Orange LED on the Ready/Data indicators go out, release the
(Start)
and
(Cancel)
buttons.
5
Close the rear cover.
• Initializes the non-volatile memory (NVM).
CAUTION:
Never attempt to turn off the printer. The printer will cease to
function.
The printer restarts automatically to apply the settings and prints the
printer settings and device settings pages.
6
Check if the factory settings are restored by referring to the Printer
Settings and Device Settings pages.
-
-
-
An error occurred while
downloading the firmware.
Turn off the printer, and then
on.
1
2
3
4
5
7
8
Cause/Remedy
Jam
Toner
Error Ready/
Data
Start Manual
Duplex
Load
Paper
Y
M
C
K