![background image](/i/dell/157615/dell-3100cn/h/dell-3100cn-017.png)
Installing the Optional Duplex Module
To Make Duplexing the Default for All Print Jobs
The optional duplex module attaches to the back side of the printer.
When installing the supplied 64MB memory card, see "
1.
Turn off the printer.
2.
Open the rear cover, and then pull it downward while holding the release catches on both sides of the inner rear cover. Pull the rear cover out to
remove it from the printer, while pushing the round blue buttons at both sides of the rear cover. Close the inner rear cover.
3.
To remove the paper cover, push in on the paper cover while pulling out on the right side of the printer cover.
4.
Insert the hooks on the optional duplex module into the grooves on the back side of the printer.
NOTE:
If you are adding an optional duplex module after setting up the printer, be sure to turn off the printer, unplug the power cable, and disconnect
all the cables from the back of the printer before completing these tasks.
NOTE:
The 64 MB memory card comes with the optional duplex module. Before you use the optional duplex module, you need to install the 64 MB
memory card on the printer. If you already have an existing memory card installed on the printer, you do not have to use the 64 MB memory card
provided with your duplex module.
NOTICE:
In steps 4 through 5, the duplex module must be supported until the support straps have been fastened.