![background image](/i/olympus/171218/olympus-cell-frap/h/olympus-cell-frap-023.png)
Manual
Chapter 4 –
Overview and Laser Safety Setup
17
4.3
Mounting the Laser Safety Kit
1.
Remove the ocular from the microscope frame and mount the ocular laser safety shutter
onto the ocular tube (with the cable on the right hand side) and fix it as shown in the photo
below.
2.
Mount the ocular back on top of the ocular laser safety shutter and tighten the holding
screw.
3.
Mount the U-shaped frame of the laser safety stage cover with the connector plugs pointing
to the right onto the microscope stage fixing it with the two M4x5 fixing screws.
4.
Place the lid of the laser safety stage cover on top of the stage frame so that the two pins on
the lid fit into the two holes of the frame that host the interlock switches.
5.
Plug the cable of the laser safety ocular shutter with one of the plugs of the laser safety stage
cover.
Fixing screws
Interlock
switches