![background image](/i/olympus/171218/olympus-cell-frap/h/olympus-cell-frap-036.png)
30
Chapter 6 –
Operating the
System
6.1
System Configuration
1.
Start the ObsConfig software to configure the excitation filters
2.
Make sure that the FRAP lasers are configured on pages
Microscope
Laser
as described
in the laser manual.
3.
Go to page
Microscope
FRAP
.
In case this page is not available right-click on OBS System Configuration (top left), open the
Components
context menu and activate
FRAP
.
4.
Click
FRAP available
to activate the
unit.
5.
Select the PC serial port (COM port) connected with the
control unit. Once selected
correctly (and with the
control unit powered up) the
Connected
field turns green.
6.
Select the
Laser
from the shortlist. Mind that this laser will not be eligible as light source for
the
Image Types
.
7.
TTL Synchronization
,
DIG I/O -> FRAP Trigger IN
. Select from the short list the TTL OUT
connection at the
imaging PC front panel that is connected with the
TRIGGER IN
of the
control unit.