![background image](/i/olympus/171218/olympus-cell-frap/h/olympus-cell-frap-024.png)
18
Chapter 4 –
Overview and Laser Safety Setup
6.
Connect the second plug of the laser safety stage cover with the
5
-pin female
STAGE
COVER
plug of the
scanning illuminator using the corresponding cable.
4.4
Connecting the
Control Unit
The installation of the
scanning illuminator is described in detail in the hardware manual. Only
the connection of the cables of the
scanning illuminator and the control unit shall be repeated
here. These steps are partly repeated in the following sub-chapters as well.
1.
Connect the
5
-pin female
STAGE COVER
plug at the LAS-BOB back panel with one of the
5-pin
SAFETY INTERLOCK
plugs at the back panel of the
control unit using the
corresponding cable.
2.
Connect the other 5-pin
SAFETY INTERLOCK
plug at the back panel of the
control
unit with one of the plugs of the laser safety stage cover (and make sure that the second one
is connected to the laser safety ocular shutter).
5-pin plugs
Translucent
insert