Chapter 39 Access Control
ES3500 Series User’s Guide
303
The following table describes the labels in this screen.
39.3.6 Configuring SNMP User
From the SNMP screen, click User to view the screen as shown. Use the User screen to create
SNMP users for authentication with managers using SNMP v3 and associate them to SNMP groups.
An SNMP user is an SNMP manager.
Figure 182
Management > Access Control > SNMP > User
Table 133
Management > Access Control > SNMP > Trap Group
LABEL
DESCRIPTION
Trap Destination IP
Select one of your configured trap destination IP addresses. These are the IP addresses
of the SNMP managers. You must first configure a trap destination IP address in the
SNMP Setting screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Type
Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Options
Select the individual SNMP traps that the Switch is to send to the SNMP station. See
for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically selects all of the
category’s traps. Clear the check boxes for individual traps that you do not want the
Switch to send to the SNMP station. Clearing a category’s check box automatically clears
all of the category’s trap check boxes (the Switch only sends traps from selected
categories).
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel
Click Cancel to begin configuring this screen afresh.