source or on the wrong
print media.
and in the printer driver.
Print media does not
stack neatly in the output
bin.
Turn the print media stack over in the tray or multipurpose feeder.
Printer does not duplex
pages.
Make sure
Duplex
is selected in both the
PCL (
Printer Control Language
)
menu on the printer
operator panel and in the printer driver.
Make sure you have enough printer memory installed.
Print Quality Problems
Problem
Action
Color is out of alignment.
· The inside of printer is dirty.
· If you install a new black cartridge and a ROS cleaning has not been done, this problem
will happen. See "
Print is too light.
· The toner may be low. Confirm the amount of the toner and change the toner cartridges if
necessary.
· Set the
Draft Mode
check box to off in the Advanced in the printer driver.
· If you are printing on an uneven print surface, change the
Paper Type
settings in the
Tray
Settings
menu. See "
· Verify that the correct print media is being used.
· The drum cartridge may need to be replaced. Change the drum cartridge.
Toner smears or print comes
off page.
· If you are printing on an uneven print surface, change the
Paper Type
settings in the
Tray
Settings
menu. See "
· Verify that the print media is within the printer specifications. See "
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
Инструкции и руководства похожие на DELL 3000cn
