Installing the Optional Duplex Module
To Make Duplexing the Default for All Print Jobs
NOTE:
If you are adding an optional duplex module after setting up the printer, be sure to turn off the printer, unplug
the power cable, and disconnect all the cables from the back of the printer before completing these tasks.
NOTE:
The 64 MB memory card comes with the optional duplex module. Before you use the optional duplex module,
you need to install the 64 MB memory card on the printer. If you already have an existing memory card installed on the
printer, you do not have to use the 64 MB memory card provided with your duplex module.
The optional duplex module attaches to the back side of the printer.
When installing the supplied 64MB memory card, see "
1. Turn off the printer.
2. Open the rear cover, and then pull it downward while holding the release catches on both sides of the inner rear cover.
Pull the rear cover out to remove it from the printer, while pushing the round blue buttons at both sides of the rear
cover. Close the inner rear cover.
3. To remove the paper cover, push in on the paper cover while pulling out on the right side of the printer cover.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
Инструкции и руководства похожие на DELL 3000cn
