56
Regulator y Notices
www
.dell.com/suppl
ies | support.dell.com
Federal Communications Commission (FCC) compliance information
statement
The Dell AIO Printer A940 has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The FCC Class B limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult your point of purchase or service representative for additional
suggestions.
The manufacturer is not responsible for any radio or television interference
caused by using other than recommended cables or by unauthorized changes or
modifications to this equipment. Unauthorized changes or modifications could
void the user's authority to operate this equipment.
NOTE:
To assure compliance with FCC regulations on electromagnetic interference for a
Class B computing device, use a properly shielded and grounded cable. Use of a substitute
cable not properly shielded and grounded may result in a violation of FCC regulations.
