![background image](/i/dell/158138/dell-c1765nfw-c1765nf/h/dell-c1765nfw-c1765nf-119.png)
Fax Settings
Purpose:
To configure the basic fax settings.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
Values:
Receive Mode
Telephone
Automatic fax reception is turned off. You can receive a fax by picking up the
handset of the external telephone, and then pressing the remote receive code.
Fax*
Automatically receives faxes.
Telephone/Fax
When the printer receives an incoming fax, the external telephone rings for the
time specified in
Auto Receive Fax/Tel
, and then the printer automatically
receives a fax. If an incoming call is not a fax, the printer beeps from the internal
speaker indicating that the call is a telephone call.
Answer
The printer can share a telephone line with an answering machine. In this mode,
Machine/
the printer will monitor the fax signal and pick up the line if there are fax tones.
Fax
If the phone communication is using serial transmission in your country (such as
Germany, Sweden, Denmark, Austria, Belgium, Italy, France and Switzerland),
this mode is not supported.
DRPD
Before using the Distinctive Ring Pattern Detection (DRPD) option, a
distinctive ring service must be installed on your telephone line by the telephone
company. After the telephone company has provided a separate number for
faxing with a distinctive ring pattern, configure the fax setup to monitor for that
specific ring pattern.
Auto Receive Fax
Sets the interval at which the printer goes into the fax receive mode after receiving an incoming
call.
Auto Receive Tel/Fax
Sets the interval at which the printer goes into the fax receive mode after the external telephone
receives an incoming call.
Auto Receive Answer/Fax
Sets the interval at which the printer goes into the fax receive mode after the external answering
machine receives an incoming call.
Line Monitor
Ring Tone Volume
Line Type
Tone/Pulse
Resend Delay
Sets the volume of the line monitor, which audibly monitors a transmission through the internal
speaker until a connection is made.
Sets the volume of the ring tone, which indicates that an incoming call is a telephone call through
the internal speaker when
Receive Mode
is set to
Telephone/Fax
.
Sets the line type.
Sets the dialing type.
Specifies the interval between transmission attempts.
Redial Attempts
Specifies the number of redial attempts to make when the destination fax number is busy. If you
enter 0, the printer will not redial.
Redial Delay
Specifies the interval between redial attempts.
Junk Fax Setup
Sets whether to reject faxes sent from unwanted numbers by accepting faxes only from the fax
numbers registered in the Phone Book.
Remote Receive
Sets whether to receive a fax by pressing a remote receive code on the external telephone.
Remote Receive Tone
Specifies the remote receive code in two digits to start
Remote Receive
.
Fax Header
Sets whether to print the information of sender on the header of faxes.
Fax Header Name
Sets the name of sender to be printed on the header of faxes. Up to 30 alphanumeric characters
can be entered.
Dell™ Printer Configuration Web Tool
117