![background image](/i/dell/158138/dell-c1765nfw-c1765nf/h/dell-c1765nfw-c1765nf-272.png)
Available Fax Settings Options
You can use the following settings options for configuring the fax system:
Option
Description
Receive Mode
Telephone
Automatic fax reception is turned off. You can receive a fax by picking up the
handset of the external telephone, and then pressing the remote receive code.
Fax
Automatically receives faxes.
Telephone/Fax
When the printer receives an incoming fax, the external telephone rings for
the time specified in
Auto Rec TEL/FAX
, and then the printer automatically
receives a fax. If an incoming call is not a fax, the printer beeps from the
internal speaker indicating that the call is a telephone call.
Ans Machine/Fax
The printer can share a telephone line with an answering machine. In this
mode, the printer will monitor the fax signal and pick up the line if there are
fax tones. If the phone communication is using serial transmission in your
country (such as Germany, Sweden, Denmark, Austria, Belgium, Italy, France
and Switzerland), this mode is not supported.
DRPD
Before using the Distinctive Ring Pattern Detection (DRPD) option, a
distinctive ring service must be installed on your telephone line by the
telephone company. After the telephone company has provided a separate
number for faxing with a distinctive ring pattern, configure the fax setup to
monitor for that specific ring pattern.
Auto Rec Fax
Sets the interval at which the printer goes into the fax receive mode after receiving an incoming call.
Auto Rec TEL/FAX
Sets the interval at which the printer goes into the fax receive mode after the external telephone
receives an incoming call.
Auto Rec Ans/FAX
Sets the interval at which the printer goes into the fax receive mode after the external answering
machine receives an incoming call.
Line Monitor
Ring Tone Volume
Line Type
Tone/Pulse
Resend Delay
Sets the volume of the line monitor, which audibly monitors a transmission through the internal
speaker until a connection is made.
Sets the volume of the ring tone, which indicates that an incoming call is a telephone call through the
internal speaker when
Receive Mode
is set to
Telephone/Fax
.
Sets the line type.
Sets the dialing type.
Specifies the interval between transmission attempts.
Redial Attempts
Specifies the number of redial attempts to make when the destination fax number is busy. If you enter
0, the printer will not redial.
Redial Delay
Specifies the interval between redial attempts.
Junk Fax Setup
Sets whether to reject faxes sent from unwanted numbers by accepting faxes only from the fax
numbers registered in the Phone Book.
Remote Receive
Sets whether to receive a fax by pressing a remote receive code on the external telephone.
Remote Rcv Tone
Specifies the remote receive code in two digits to start
Remote Receive
.
Fax Header
Sets whether to print the information of sender on the header of faxes.
Fax Header Name
Sets the name of sender to be printed on the header of faxes. Up to 30 alphanumeric characters can be
entered.
Fax Number
Sets the fax number of the printer to be printed on the header of faxes.
Fax Cover Page
Sets whether to attach a cover page to faxes.
DRPD Pattern
Sets the DRPD setting from
Pattern 1
to
Pattern 7
. DRPD is a service provided by some telephone
companies.
Faxing
270