ENGLISH
LINT TRAY
With the lint tray located in this position, it will collect all your waste material.
After completion of work if you then turn tray upwards in direction shown, finger Ref C will locate in
slot D and left hand pin will slide into lower hole B.
In either position if you gently push the tray to the left it will lock more securely into position and
avoids the possibility of it moving out of position.
CUTTING WIDTH GAUGE
When using cutting width gauge, the fabric is cut down and sewn at same distance from the edge
of fabric within the distance of the width adjuster.
THREAD CUTTER
Thread cutter is built in needle plate. Trim thread near the end of fabric by pushing down the lever
as illustrated.
CHANGING PRESSER FEET
Be sure needle is in the up position. Raise presser foot lever.
1. Push foot release lever
to remove the foot.
2. Place the desired foot on the needle plate aligning needle holes.
3. Lower the presser foot lever and push foot release lever so that the foot holder snaps on the
foot.
Illustration *
: Turn upwards
*
: Foot release lever
12
D
C
B
*
*