![background image](/i/jaguar/82691/jaguar-087-dw/h/jaguar-087-dw-056.png)
ENGLISH
3. CARING FOR YOUR MACHINE
REPLACING MOVING CUTTER
Replace a moving cutter if it becomes blunt as follows. A spare cutter will be found in your
accessories.
NOTE: You should not need to replace fixed cutter, which is made of a special hard alloy material.
FIRST REMOVE THE POWER PLUG FROM THE SUPPLY SOCKET-OUTLET.
1. Loosen screw and take out moving cutter.
2. Close the working table. Lower cutter driving arm to its lowest position by turning the hand wheel
towards you by hand. In this position, set replacement cutter in position and secure it with screw,
ENSURING THAT THE EDGE OF THE MOVING CUTTER IS APPROXIMATELY 0.5 MM
BELOW THE SURFACE OF THE FIXED CUTTER.
DISENGAGING MOVING CUTTER
If you want to sew without cutting, open the working table and disengage the moving cutter by
pushing the cutter release knob to the left and turning it towards you as illustrated.
Ensure that fabric edge is not wider than overedge width selected or upper looper and needle can
be damaged.
REMOVING FACE COVER
Disconnect from power supply before removing face cover.
Remove the screw and take off the face cover.
Illustration *
: Screw
*
: Moving cutter
*
: Cutter release knob
*
: Face cover
54
*
*
0.5 mm
*
A
*
*