Fig. 3
Fig.4
Fig. 1
ENGLISH
THREE-THREAD OVERLOCK WITH ONE NEEDLE
By threading the LEFT needle only a width of 6 mm will be produced and by threading the RIGHT
needle only a width of 3.8 mm will be produced.
Please keep the unused needle on the needle pad as illustrated.
CONVERTING TO TWO-THREAD USE
To convert to two thread use, first open the front cover and working table and raise needle to its
highest point by turning hand wheel towards you. Remove the right needle and use the left needle.
Please keep the unused needle on the needle pad.
Pull out the converter as shown in Fig. 1.
Attach the two-thread converter onto the upper looper as shown in Fig. 2, Fig. 3, making sure that
you slide tail end in first then locate hook end into looper hole.
When not using converter, insert it deep and keep as illustrated in Fig. 4.
Illustration *
: Two-thread overlock convertor
*
: Upper looper
32
1
2
Fig. 2
*
*
1
2