![background image](/i/jaguar/82691/jaguar-087-dw/h/jaguar-087-dw-066.png)
ENGLISH
PIPING FOOT
Prepare a piece of ready-made piping (corded bias fold tape).
Place folded piping between seam edges with fold extending beyond seam line toward garment.
Pin or baste, and stitch the seam.
Braid or ribbon may also be used, either flat or folded braid can be used in straight seams.
Use for decorating edges of collars, cuffs, pockets, etc.
PEARL FOOT
1. PEARLS ALONG AN EDGE:
Set for left needle (remove right needle) 3-thread overlock.
Set tensions as follows:
Left needle: 4
Upper looper: 1 - 2
Lower looper: 7 - 8
SEW:
Remove regular foot; replace with pearl foot.
Remove stitch finger as you did for a rolled edge.
Swing cutter away to lowest position, close from covers.
Raise the needle to it's highest position.
Place pearls in the channel on the right side of the foot with 2" of pearls extending behind foot.
Take one stitch with the hand wheel to secure the pearls.
Follow edge of fabric along fabric guide.
Sew pearls on edge of fabric.
Return cutter to original position when finished.
2. PEARLS SEWN WITH A FLAT LOCK STITCH:
FABRIC:
Medium weight woven
2 or 4 mm pearls
Set for a 3-thread flat lock, left needle only. See pg.
SEW:
Remove regular foot; replace with pearl foot.
Insert small stitch finger.
Swing cutter away to lowest position.
Raise needle to it's highest position.
Place pearls in channel on right side of the foot with 2" of pearls extending behind foot.
Take one stitch with the hand wheel to secure the pearls.
Sew pearls on with the left needle just catching the fold of the fabric.
Pull flat lock open.
64