![background image](/i/jaguar/82691/jaguar-087-dw/h/jaguar-087-dw-046.png)
EFFECT AND
APPLICATION
TYPE OF FEEDING
FEED RATIO
REAR: FRONT
SETTING
Waver-free SeamS,
Gathering
PoSitive
differential feed
1-2
No differential feed
Neutral feed
1
Pucker-free SeamS
Negative
differential feed
0.7-1
ENGLISH
SETTING DIFFERENTIAL FEED
Set by simply turning the differential feed control dial in the direction desired referring to the chart
below.
The adjustment can be made between 0.7 (negative effect) and 2 (Positive effect). These settings
give the best ratio of feeding.
For normal sewing, the dial should be set at 1.
The dial can be reset even while sewing.
FOOT PRESSURE REGULATOR
Presser foot pressure has been correctly set at the factory, so you do not need to adjust it for most
of ordinary sewing. If adjustment is necessary, turn the foot pressure regulator to higher number to
increase or to lower number to decrease pressure.
SEWING WITH EXTRA HEAVYWEIGHT FABRIC OR MULTIPLE
LAYERS OF FABRIC
A wide range of fabric can be overlocked on this machine, but it is recommended to tighten screw
as illustrated, when sewing with extra heavyweight fabrics or mulitiple layers of fabric. Open working
table for adjustment.
Loosen the screw when sewing with light to normal weight fabric or turning overedge cutting width
dial, or otherwise fabric may not be well cut.
The machine is set for normal weight fabrics from the factory.
Illustration *
: Differential feed control dial
*
: Increase
*
: Decrease
*
: Tighten
*
: Loosen
*
: Screw
44
*
*
*
*
*
*