Safety Information

5  

1

Saf
et

y Inf

orma

tion

•  Before operating, please check proper temperature, 

humidity and power source ratings.  
Use the camera under conditions where temperature 
is from -10 °C to 50 °C and humidity is below 80 %. The 
input power source is AC 24 V.

•  Consumables  

Parts having contacts such as the lens-drive motors, 
cooling fan built inside the camera are subject to wear 
with time. About replacement and maintenance of 
such parts, please ask the nearest service center.

Camera Installation Location

Discuss the installation location for the camera with your 
retailer, and select a place that is strong enough
for the installation.
•  Install the camera on a ceiling (concrete, etc.) at a 

location that is sufficiently strong to support it.

•  Install the camera body on the foundation section 

of the building or sections having sufficient bearing 
strength.

Never install or use the camera in the following 

locations

•  Do not install it in areas exposed to direct sunlight or 

rain.

•  Do not install the camera near the air outlet of an air 

conditioner.

•  Near a swimming pool or other areas where chemicals 

are used.

•  Food preparation areas and other locations where there 

are large amounts of steam vapor and oil, in flammable 
atmospheres, other special environments.

•  Areas where radiation, X-rays, strong electric waves, or 

magnetism is generated.

•  At sea, in coastal areas, or in areas where corrosive gas 

is being generated.

•  Areas outside of the allowable ambient operating 

temperature range.

About Static Electricity Removal

Before installing the camera, touch a metal case or other 
metallic parts with your hand to remove static electricity 
from your body.
Do not install in areas subjected to high amounts of 
humidity or dust.
Doing so may cause internal components to damage more 
easily or malfunction.
Do not wire cables near power lines.

Tightening the Screws

Screws should be tightened sufficiently in accordance with 
the materials and structure of the installation location. After 
tightening the screws, visually inspect them to make sure 
there is no unevenness and that each screw is tight.