Инструкция для ZYXEL GS2200-24P

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 20 Classifier

GS2200-24 User’s Guide

177

Ethernet
Type

Select an Ethernet type or select Other and enter the Ethernet type number in
hexadecimal value. Refer to

Table 48 on page 178

for information.

Source
MAC
Address

Select Any to apply the rule to all MAC addresses.

To specify a source, select the second choice and type a MAC address in valid
MAC address format (six hexadecimal character pairs).

Port

Type the port number to which the rule should be applied. You may choose one
port only or all ports (Any).

Destination
MAC
Address

Select Any to apply the rule to all MAC addresses.

To specify a destination, select the second choice and type a MAC address in
valid MAC address format (six hexadecimal character pairs).

Layer 3

Specify the fields below to configure a layer 3 classifier.
IP
Protocol

Select an IP protocol type or select Other and enter the protocol number in
decimal value. Refer to

Table 49 on page 179

for more information.

You may select Establish Only for TCP protocol type. This means that the
Switch will pick out the packets that are sent to establish TCP connections.

Source
IP
Address/
Address
Prefix

Enter a source IP address in dotted decimal notation.

Specify the address prefix by entering the number of ones in the subnet mask.

A subnet mask can be represented in a 32-bit notation. For example, the
subnet mask “255.255.255.0” can be represented as
“11111111.11111111.11111111.00000000”, and counting up the number of
ones in this case results in 24.

Socket
Number

Note: You must select either

UDP

TCP

in the

IP Protocol

field before

you configure the socket numbers.

Select Any to apply the rule to all TCP/UDP protocol port numbers or select
the second option and enter a TCP/UDP protocol port number. Refer to

Table

50 on page 179

for more information.