Инструкция для ZYXEL GS2200-24P

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 32 Access Control

GS2200-24 User’s Guide

287

32.4 Configuring SNMP Trap Group

Use the Trap Group screen to specify the types of SNMP traps that should be sent
to each SNMP manager.

Click Management > Access Control > SNMP > Trap Group to view the screen
as shown.

Figure 158

Management > Access Control > SNMP > Trap Group (GS2200-24P)

The following table describes the labels in this screen.

Table 91

Management > Access Control > SNMP > Trap Group

LABEL

DESCRIPTION

Trap
Destination IP

Select one of your configured trap destination IP addresses. These are
the IP addresses of the SNMP managers. You must first configure a trap
destination IP address in the SNMP Setting screen.

Use the rest of the screen to select which traps the Switch sends to that
SNMP manager.

Type

Select the categories of SNMP traps that the Switch is to send to the
SNMP manager.

Options

Select the individual SNMP traps that the Switch is to send to the SNMP
station. See

Section on page 293

for individual trap descriptions.

The traps are grouped by category. Selecting a category automatically
selects all of the category’s traps. Clear the check boxes for individual
traps that you do not want the Switch to send to the SNMP station.
Clearing a category’s check box automatically clears all of the category’s
trap check boxes (the Switch only sends traps from selected categories).

Note: The

poe

and

fanspeed

options are only available to GS2200-

24P.

Apply

Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.