Chapter 7 System Status and Port Statistics
GS2200-24 User’s Guide
69
The following table describes the labels in this screen.
Table 7
Status
LABEL
DESCRIPTION
Port
This identifies the Ethernet port. Click a port number to display the Port
Details screen (refer to
Name
This is the name you assigned to this port in the Basic Setting > Port
Setup screen.
Link
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps
or 1000M for 1000Mbps) and the duplex (F for full duplex or H for half).
It also shows the cable type (Copper or Fiber) for the combo ports.
State
If STP (Spanning Tree Protocol) is enabled, this field displays the STP
state of the port (see
for more information).
If STP is disabled, this field displays FORWARDING if the link is up,
otherwise, it displays STOP.
PD
(for GS2200-24P only) This field displays whether or not a powered
device (PD) is allowed to receive power from the Switch on this port.
LACP
This fields displays whether LACP (Link Aggregation Control Protocol) has
been enabled on the port.
TxPkts
This field shows the number of transmitted frames on this port.
RxPkts
This field shows the number of received frames on this port.
Errors
This field shows the number of received errors on this port.
Tx KB/s
This field shows the number of kilobytes per second transmitted on this
port.
Rx KB/s
This field shows the number of kilobytes per second received on this port.
Up Time
This field shows the total amount of time in hours, minutes and seconds
the port has been up.
Clear Counter Enter a port number and then click Clear Counter to erase the recorded
statistical information for that port, or select Any to clear statistics for all
ports.