![background image](/i/zyxel/144895/zyxel-zywall-2-ee/h/zyxel-zywall-2-ee-410.png)
ZyWALL 2 Series User’s Guide
26-12
Remote Node Setup
Table 26-6 Menu 11.6: Traffic Redirect Setup
FIELD
DESCRIPTION
EXAMPLE
Active
Press [SPACE BAR] and select
Yes
(to enable) or
No
(to disable) traffic
redirect setup. The default is
No
.
When the
Active
field is
Yes
, you must configure every field in this screen
unless you are using PPPoE or PPTP encapsulation (except
Check WAN
IP Address
and
Timeout
).
If you don’t configure these fields and are using PPTP or PPPoE
encapsulation, then the ZyWALL checks the PPPoE channel or PPTP
tunnel to determine if the WAN connection is down.
Yes
Configuration:
Backup Gateway
IP Address
Enter the IP address of your backup gateway in dotted decimal notation.
The ZyWALL automatically forwards traffic to this IP address if the
ZyWALL’s Internet connection terminates.
0.0.0.0
Metric
Enter a number from 1 to 15 to set this route’s priority among the
ZyWALL’s routes (see the
Metric
section in the
WAN and Dial Backup
Setup
chapter) The smaller the number, the higher priority the route has.
15
(default)
Check WAN IP
Address
Enter the IP address of a reliable nearby computer (for example, your
ISP’s DNS server address) to test your ZyWALL’s WAN accessibility.
The ZyWALL uses the default gateway
IP address if you do not enter an
IP address here.
If you are using PPTP or PPPoE Encapsulation, enter “0.0.0.0” to
configure the ZyWALL to check the PVC (Permanent Virtual Circuit) or
PPTP tunnel.
0.0.0.0
Fail Tolerance Enter the number of times your ZyWALL may attempt and fail to connect
to the Internet before traffic is forwarded to the backup gateway. Two to
five is usually a good number.
2
Period (sec) Enter the time interval (in seconds) between WAN connection checks.
Five to 60 is usually a good number.
5
Timeout (sec) Enter the number of seconds the ZyWALL waits for a ping response from
the IP Address in the
Check WAN IP Address
field before it times out.
The number in this field should be less than the number in the
Period
field. Three to 50 is usually a good number.
The WAN connection is considered “down” after the ZyWALL times out
the number of times specified in the
Fail
Tolerance
field.
3