![background image](/i/zyxel/144895/zyxel-zywall-2-ee/h/zyxel-zywall-2-ee-093.png)
ZyWALL 2 Series User’s Guide
WAN Screens
6-9
Table 6-6 PPTP Encapsulation
LABEL DESCRIPTION
User Name
Type the user name given to you by your ISP.
Password
Type the password associated with the User Name above.
Retype to Confirm
Type your password again to make sure that you have entered is correctly.
Nailed-up
Connection
Select
Nailed-Up Connection
if you do not want the connection to time out.
Idle Timeout
This value specifies the time in seconds that elapses before the ZyWALL
automatically disconnects from the PPTP server.
PPTP Configuration
My IP Address
Type the (static) IP address assigned to you by your ISP.
My IP Subnet Mask
Your ZyWALL will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the ZyWALL.
Server IP Address
Type the IP address of the PPTP server.
Connection ID/Name Type your identification name for the PPTP server.
Apply
Click
Apply
to save your changes back to the ZyWALL.
Reset
Click
Reset
to begin configuring this screen afresh.
6.6 Configuring WAN IP
To change your ZyWALL’s WAN IP settings, click
WAN
, then the
WAN IP
tab.
This screen varies
according to the type of encapsulation you select.
If your ISP did
not
assign you a fixed IP address, click
Get automatically from ISP (Default
);otherwise
click
Use fixed IP Address
and enter the IP address in the following field.
When
Network Address Translation
is set to
Full Feature
, but there is no NAT rule
configured, the warning message “
Warning! No NAT rule configured in system
”
appears in the status bar.