TILT AND TELESCOPIC OPERATION
To adjust the steering wheel move the switch
䊊
1
in the following directions:
●
Adjust the steering wheel forward or back-
ward in direction
䊊
3
to the desired tele-
scopic position.
●
Adjust the steering wheel up or down in
direction
䊊
2
to the desired tilt position.
CAUTION
For vehicles with automatic drive posi-
tioner: Failure to reset the tilt and tele-
scoping functions of the steering wheel,
after the vehicle’s battery has been dis-
charged, may prevent the steering wheel
position from being adjusted.
For vehicles with automatic drive positioner: Both
the tilt and telescopic steering operation must be
reset after the vehicle’s battery has been dis-
charged in order to prevent the tilt and telescopic
operation from locking in one position. When the
battery has been recharged or replaced, perform
the following:
●
For telescopic operation: Adjust the switch
䊊
1
so the steering wheel moves to the most
forward and backward position
䊊
3
that can
be reached.
●
For tilt operation: Adjust the switch
䊊
1
so
the steering wheel moves to the highest
position
䊊
2
that can be reached.
Performing these operations resets the range of
the steering wheel’s tilt and telescopic function.
Entry/Exit function
The automatic drive positioner system will make
the steering wheel move up automatically when
the driver’s door is opened and the ignition
switch is in the LOCK position. This lets the driver
get into and out of the seat more easily. The
steering wheel moves back into position when
the driver’s door is closed and the ignition switch
is pushed.
For more information, see “Automatic drive posi-
tioner” in this section.
WPD0366
Pre-driving checks and adjustments
3-27