For further instructions on using the Climate con-
trol system see “Heater and air conditioner (au-
tomatic)” in “Monitor, climate, audio, phone and
voice recognition systems”.
For further instructions on using the Navigation
System see the separate Navigation System
Owner’s Manual.
For further instructions on using the Audio sys-
tem see “Audio system” in “Monitor, climate, au-
dio, phone and voice recognition systems”.
SYSTEM OPERATION
The automatic drive positioner system will not
work or will stop operating under the following
conditions:
●
When the vehicle speed is above 4 MPH
(7 km/h).
●
When any of the memory switches are
pushed while the automatic drive positioner
is operating.
●
When the adjusting switch for the driver’s
seat and steering column is turned on while
the automatic drive positioner is operating.
●
When the seat has already been moved to
the memorized position.
●
When no seat position is stored in the
memory switch.
●
When the shift selector is moved from P
(Park) to any other position.
●
When the driver’s door remains open more
than 45 seconds and the ignition switch is
not in the ON position.
●
The seat synchronization function is auto-
matically disabled if the outside mirrors or
steering wheel reaches its maximum adjust-
ment.
●
The seat synchronization function will not
operate if the seat is adjusted over one of the
following maximum thresholds:
– Seat sliding: 3.0 in (76 mm)
– Seatback reclining: 9.1 degrees
– Seat lifter (rear side): 0.8 in (20 mm)
The entry/exit function can be adjusted or can-
celed through the Vehicle Settings in the vehicle
information display by performing the following:
●
Switch the Exit Seat Slide from ON to OFF.
●
Switch the Exit Steering UP from ON to
OFF.
Pre-driving checks and adjustments
3-35