Инструкция для INFINITI JX35 (2013)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

●

Make sure the area around the vehicle is
clear.

●

Check fluid levels such as engine oil, cool-
ant, brake fluid, and windshield-washer fluid
as frequently as possible, or at least when-
ever you refuel.

●

Check that all windows and lights are clean.

●

Visually inspect tires for their appearance
and condition. Also check tires for proper
inflation.

●

Check that all doors are closed.

●

Position seat and adjust head restraint.

●

Adjust inside and outside mirrors.

●

Fasten seat belts and ask all passengers to
do likewise.

●

Check the operation of warning lights when
the ignition switch is placed in the ON posi-
tion. See “Warning/indicator lights and au-
dible reminders” in the “Instruments and
controls” section of this manual.

1. Apply the parking brake.

2. Move the shift selector to P (Park) or N

(Neutral). P (Park) is recommended.

The starter is designed not to operate if
the shift selector is in any of the driving
positions.

3. Push the ignition switch to the ON position.

Depress the brake pedal and push the igni-
tion switch to start the engine.

To start the engine immediately, push and
release the ignition switch while depressing
the brake pedal with the ignition switch in
any position.

●

If the engine is very hard to start in ex-
tremely cold weather or when restarting,
depress the accelerator pedal a little (ap-
proximately 1/3 to the floor) and while
holding, crank the engine. Release the
accelerator pedal when the engine starts.

●

If the engine is very hard to start because
it is flooded, depress the accelerator
pedal all the way to the floor and hold it.
Push the ignition switch to the ON posi-
tion to start cranking the engine. After 5 or
6 seconds, stop cranking by pushing the
ignition switch to LOCK. After cranking
the engine, release the accelerator pedal.
Crank the engine with your foot off the

accelerator pedal by depressing the
brake pedal and pushing the push-button
ignition switch to start the engine. If the
engine starts, but fails to run, repeat the
above procedure.

CAUTION

Do not operate the starter for more than
15 seconds at a time. If the engine does
not start, push the ignition switch to the
OFF position and wait 10 seconds before
cranking again, otherwise the starter
could be damaged.

Warm-up

Allow the engine to idle for at least 30 sec-
onds after starting. Do not race the engine
while warming it up. Drive at moderate
speed for a short distance first, especially in
cold weather. In cold weather, keep the en-
gine running for a minimum of 2 - 3 minutes
before shutting it off. Starting and stopping
the engine over a short period of time may
make the vehicle more difficult to start.

5. To stop the engine, place the shift selector

into the P (Park) position and push the igni-
tion switch to the OFF position.

BEFORE STARTING THE ENGINE

STARTING THE ENGINE

5-14

Starting and driving