Use the following steps to mount the front license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the plastic
bag:
Only use the recommended mounting position,
otherwise the Intelligent Cruise Control (ICC)
sensor obstruction (if so equipped) may result.
●
License plate bracket
●
License plate bracket (J-nut) screws x 2
●
License plate screws x 2
●
Screw grommets x 2
1. Park the vehicle on flat, level ground.
2. Locate the center position
䊊
A
as illustrated.
Line up the license plate bracket under the
top of the front bumper
䊊
B
with the tabs
䊊
C
.
Hold the license plate bracket in place.
3. Mark the center of the hole
䊊
D
with a felt-tip
pen.
4. Carefully drill two pilot holes using a 0.39 in
(10 mm) drill bit at the marked locations.
(Be
sure that the drill only goes through the
bumper fascia.)
5. Insert the grommets into the holes in the
bumper fascia.
LTI2035
INSTALLING FRONT LICENSE PLATE
9-12
Technical and consumer information