Инструкция для INFINITI JX35 (2013)

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

●

Allow more stopping distance under
these conditions. Braking should be
started sooner than on dry pavement.

●

Allow greater following distances on
slippery roads.

●

Watch for slippery spots (glare ice).
These may appear on an otherwise
clear road in shaded areas. If a patch of
ice is seen ahead, brake before reach-
ing it. Try not to brake while on the ice,
and

avoid

any

sudden

steering

maneuvers.

●

Do not use the cruise control on slip-
pery roads.

●

Snow can trap dangerous exhaust
gases under your vehicle. Keep snow
clear of the exhaust pipe and from
around your vehicle.

ENGINE BLOCK HEATER (if so
equipped)

Engine block heaters are used to assist with cold
temperature starting.

The engine block heater should be used when
the outside temperature is 20°F (-7°C) or lower.

WARNING

●

Do not use your engine block heater
with an ungrounded electrical system
or a 2-pronged adapter. You can be se-
riously injured by an electrical shock if
you use an ungrounded connection.

●

Disconnect and properly store the en-
gine block heater cord before starting
the engine. Damage to the cord could
result in an electrical shock and can
cause serious injury.

●

Use a heavy-duty 3-wire, 3-pronged ex-
tension cord rated for at least 10 A. Plug
the extension cord into a Ground Fault
Interrupt

(GFI)

protected,

grounded

110-VAC outlet. Failure to use the
proper extension cord or a grounded
outlet can result in a fire or electrical
shock

and

cause

serious

personal

injury.

To use the engine block heater:

1. Turn the engine off.

2. Open the hood and unwrap the engine block

heater cord.

3. Plug the engine block heater cord into a

grounded

3-wire,

3-pronged

extension

cord.

4. Plug the extension cord into a Ground Fault

Interrupt (GFI) protected, grounded 110-
volt AC (VAC) outlet.

5. The engine block heater must be plugged in

for at least 2 - 4 hours, depending on outside
temperatures, to properly warm the engine
coolant. Use an appropriate timer to turn the
engine block heater on.

6. Before starting the engine, unplug and prop-

erly store the cord to keep it away from
moving parts.

Starting and driving

5-97