![background image](/i/infiniti/147975/infiniti-m35-2009/h/infiniti-m35-2009-103.png)
The rear outboard seats are warmed by built-in
heaters. The switches located on the inside of
the rear center armrest can be operated inde-
pendently of each other.
1. Start the engine.
2. Select heat range.
䊊
1
For high heat, push the HI (High) side of
the switch.
䊊
2
For low heat, push the LO (Low) side of
the switch.
The indicator light in the switch
䊊
3
will
illuminate when low or high is selected.
3. To turn off the heater, push the HI or LO
side (which is selected) of the switch.
Make sure the indicator light turns off.
The heater is controlled by a thermostat,
automatically turning the heater on and off.
The indicator light will remain on as long as
the switch is on.
When the vehicle’s interior is warmed, or
before you leave the vehicle, be sure to turn
off the switch.
The climate controlled seat warms up or cools
down the front seats by blowing warm or cool
air from the surface of the seat. The switches
located on the center console can be operated
independently of each other.
1. Start the engine.
2. Turn the control knob
䊊
A
to the H (Heat)
side
䊊
1
or to the C (Cool) side
䊊
2
. The
indicator light
䊊
B
on the control knob will
illuminate.
3. Adjust the desired amount of the air using
the control knob
䊊
A
.
The climate controlled seat blower remains
on low speed for approximately 60 seconds
after turning the switch on or selecting the
desired temperature.
SIC2770
SIC2771
CLIMATE CONTROLLED SEATS (front seats)
Instruments and controls
2-35
췽
—
—
05/23/08—pattie
墍