![background image](/i/infiniti/147975/infiniti-m35-2009/h/infiniti-m35-2009-150.png)
8. Push the SET switch and, within 5 sec-
onds, push the memory switch (1 or 2)
selected in step 3 fully for at least 1
second.
●
The indicator light for the pushed memory
switch will stay on for approximately 5
seconds after pushing the switch. After
the indicator light goes off, the selected
mirror position is stored in the selected
memory (1 or 2).
9. Turn the outside mirror control switch to R
(right).
Repeat the above procedure to adjust the
right mirror position and store in the se-
lected memory.
●
When the driver’s seat, outside mirror and
steering column are not in the memorized
position, the outside mirror will move
with the initial tilt-down angle, if the
reverse tilt-down position is stored.
Linking Intelligent Key to a stored
memory position
The Intelligent Key can be linked to a stored
memory position with the following procedure.
1. Follow the steps for storing a memory
position.
2. While the indicator light for the memory
switch being set is illuminated for 5 sec-
onds, push the
button on the Intel-
ligent Key. If the indicator light blinks, the
Intelligent Key is linked to that memory
setting.
Push the ignition switch to the LOCK position,
and push the
button on the Intelligent
Key. The driver’s seat, steering wheel and out-
side mirrors will move to the memorized posi-
tion.
Confirming memory storage
●
Push the ignition switch to the ON position
and push the SET switch. If the main memory
has not been stored, the indicator light will
come on for approximately 0.5 second.
When the memory has stored in position, the
indicator light will stay on for approximately
5 seconds.
●
If the battery cable is disconnected, or if the
fuse opens, the memory will be canceled. In
this case, reset the desired position using
the previous procedure.
●
If optional Intelligent Keys are added to your
vehicle, perform the memory storage proce-
dure to switch (1 or 2) and linking Intelligent
Key procedure to a stored memory position
again for each Intelligent Key. For additional
Intelligent Key information, see “KEYS” ear-
lier in this section.
Selecting the memorized position
1. Move the selector lever to the P (Park)
position.
2. Use one of the following methods to move
the driver’s seat, steering column and
outside mirrors.
●
Push the ignition switch to the ON posi-
tion and push the memory switch (1 or 2)
fully for at least 1 second.
●
Within 45 seconds after opening the driv-
er’s door, push the memory switch (1 or 2)
fully for at least 1 second.
The driver’s seat, steering column and
outside mirrors will move to the memo-
rized position with the indicator light
flashing, and then the light will stay on for
approximately 5 seconds.
3-28
Pre-driving checks and adjustments
췽
—
—
05/23/08—pattie
墍