![background image](/i/infiniti/147975/infiniti-m35-2009/h/infiniti-m35-2009-121.png)
4. Hold down both buttons until the indica-
tor light on HomeLink
姞
flashes, changing
from a “slow blink” to a “rapid blink”.
This could take up to 90 seconds. When
the indicator light blinks rapidly, both
buttons may be released. The rapidly
flashing light indicates successful pro-
gramming. To activate the garage door or
other programmed device, push and hold
the programmed HomeLink
姞
button - re-
leasing when the device begins to acti-
vate.
5. If the indicator light on HomeLink
姞
blinks
rapidly for two seconds and then turns
solid, HomeLink
姞
has picked up a “rolling
code” garage door opener signal. You will
need to proceed with the next steps to
train HomeLink
姞
, completing the pro-
gramming may require a ladder and an-
other person for convenience.
6. Push and release the program button
located on the garage door opener’s mo-
tor to activate the “training mode”. This
button is usually located near the an-
tenna wire that hangs down from the
motor. If the wire originates from under a
light lens, you will need to remove the
lens to access the program button.
NOTE:
Once you have pushed and released the training
button on the garage door opener’s motor and
the “training light” is lit, you have 30 seconds in
which to perform step 7. For convenience, use
the help of a second person to assist when per-
forming this step.
7. Quickly (within 30 seconds of pushing
and releasing the garage door opener
program button) and firmly push and re-
lease the HomeLink
姞
button you’ve just
programmed.
Push
and
release
the
HomeLink
姞
button up to three times to
complete the training.
8. Your HomeLink
姞
button should now be
programmed.
To program the remaining HomeLink
姞
buttons
for additional door or gate openers, follow
steps 2 through 8 only.
NOTE:
Do not repeat step 1 unless you want to “clear”
all previously programmed HomeLink
姞
buttons.
If you have any questions or are having diffi-
culty programming your HomeLink
姞
buttons,
please refer to the HomeLink
姞
web site at:
www.homelink.com or call 1-800-355-3515.
PROGRAMMING HOMELINK
姞
FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required hand-
held transmitters to stop transmitting after 2
seconds. To program your hand-held transmit-
ter to HomeLink
姞
, continue to push and hold
the HomeLink
姞
button (note steps 2 through 4
under “Programming HomeLink
姞
”) while you
push and re-push (“cycle”) your hand-held
transmitter every 2 seconds until the indicator
light flashes rapidly (indicating successful pro-
gramming).
NOTE:
If programming a garage door opener, etc., it is
advised to unplug the device during the “cy-
cling” process to prevent possible damage to
the garage door opener components.
OPERATING THE HOMELINK
姞
UNIVERSAL TRANSCEIVER
HomeLink
姞
Universal Transceiver (once pro-
grammed) may now be used to activate the
garage door, etc. To operate, simply push the
appropriate programmed HomeLink
姞
Universal
Transceiver button. The red indicator light will
illuminate while the signal is being transmitted.
Instruments and controls
2-53
췽
—
—
05/23/08—pattie
墍