![background image](/i/infiniti/147975/infiniti-m35-2009/h/infiniti-m35-2009-040.png)
7. After attaching the child restraint, test it
before you place the child in it. Push it
from side to side while holding the seat
near the LATCH attachment path. The
child restraint should not move more than
1 inch (25 mm) from side to side. Try to tug
it forward and check to see if the LATCH
attachment holds the restraint in place. If
the restraint is not secure, tighten the
LATCH attachment as necessary, or put
the restraint in another seat and test it
again. You may need to try a different
child restraint. Not all child restraints fit
in all types of vehicles.
8. Check to make sure the child restraint is
properly secured prior to each use. If the
child restraint is loose, repeat steps 4
through 7.
Rear-facing
Follow these steps to install a rear-facing child
restraint using LATCH system:
1. If your vehicle is equipped with rear power
seat adjustment, adjust the rear outboard
seats to the upright and rearmost posi-
tion. (See “REAR SEATS” earlier in this
section.)
2. Position the child restraint on the seat.
Always follow the child restraint manufac-
turer’s instructions.
3. Secure the child restraint anchor attach-
ments to the LATCH lower anchors. Check
to make sure the LATCH attachment is
properly attached to the lower anchors.
Front-facing — step 7
SSS0638
Rear-facing (webbing-mounted) — step 3
SSS0648
1-22
Safety — Seats, seat belts and supplemental restraint system
췽
—
—
08/12/08—pattie
墍