Инструкция для SONY MDS-JB920

(скачивание инструкции бесплатно)
Формат файла: PDF
Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.
Дополнительно: Чтение инструкции онлайн
background image

2

EN

WARNING

To prevent fire or shock
hazard, do not expose the unit
to rain or moisture.
To avoid electrical shock, do
not open the cabinet.  Refer
servicing to qualified
personnel only.

The laser component in this product
is capable of emitting radiation
exceeding the limit for Class 1.

This appliance is classified as a CLASS 1
LASER product.  The CLASS 1 LASER
PRODUCT MARKING is located on the
rear exterior.

The following caution label is located
inside of the unit.

IN NO EVENT SHALL SELLER BE
LIABLE FOR ANY DIRECT,
INCIDENTAL OR
CONSEQUENTIAL DAMAGES OF
ANY NATURE, OR LOSSES OR
EXPENSES RESULTING FROM
ANY DEFECTIVE PRODUCT OR
THE USE OF ANY PRODUCT.

Precautions

On safety

Should any solid object or liquid fall
into the cabinet, unplug the deck and
have it checked by qualified personnel
before operating it any further.

On power sources

• Before operating the deck, check that

the operating voltage of the deck is
identical with your local power
supply.  The operating voltage is
indicated on the nameplate at the rear
of the deck.

• The unit is not disconnected from the

AC power source (mains) as long as it
is connected to the wall outlet, even if
the unit itself has been turned off.

• If you are not going to use the deck

for a long time, be sure to disconnect
the deck from the wall outlet.  To
disconnect the AC power cord, grasp
the plug itself;  never pull the cord.

• AC power cord must be changed only

at the qualified service shop.

On operation

If the deck is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may
condense on the lenses inside the deck.
Should this occur, the deck may not
operate properly.  In this case, remove
the MD and leave the deck turned on
for about an hour until the moisture
evaporates.

On the MiniDisc cartridge

• Do not open the shutter to expose the

MD.

• Do not place the cartridge where it

will be subject to extremes of
sunlight, temperature, moisture or
dust.

On cleaning

Clean the cabinet, panel and controls
with a soft cloth slightly moistened with
a mild detergent solution.  Do not use
any type of abrasive pad, scouring
powder or solvent such as alcohol or
benzine.

If you have any questions or problems
concerning your deck, please consult
your nearest Sony dealer.

Welcome!

Thank you for purchasing the Sony
MiniDisc Deck.  Before operating the
deck, please read this manual
thoroughly and retain it for future
reference.

About This Manual

Conventions

• Controls in the instructions are those

on the deck; these may, however, be
substituted by controls on the remote
that are similarly named or, when
different, appear in the instructions
within brackets.

• The following icons are used in this

manual:

Z

Indicates a procedure that
requires use of the remote.

z

Indicates tips for making the
task easier and hints.

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
Оглавление инструкции

Document Outline