![background image](/i/zyxel/148838/zyxel-gs2200-24p/h/zyxel-gs2200-24p-232.png)
Chapter 25 IP Source Guard
GS2200-24 User’s Guide
232
open this screen, click Advanced Application > IP Source Guard > DHCP
Snooping > Configure > VLAN.
Figure 120
DHCP Snooping VLAN Configure
The following table describes the labels in this screen.
Table 70
DHCP Snooping VLAN Configure
LABEL
DESCRIPTION
Show VLAN
Use this section to specify the VLANs you want to manage in the
section below.
Start VID
Enter the lowest VLAN ID you want to manage in the section below.
End VID
Enter the highest VLAN ID you want to manage in the section below.
Apply
Click this to display the specified range of VLANs in the section below.
VID
This field displays the VLAN ID of each VLAN in the range specified
above. If you configure the * VLAN, the settings are applied to all
VLANs.
Enabled
Select Yes to enable DHCP snooping on the VLAN. You still have to
enable DHCP snooping on the Switch and specify trusted ports.
Note: If DHCP is enabled and there are no trusted ports, DHCP
requests will not succeed.
Option82
Select this to have the Switch add the slot number, port number and
VLAN ID to DHCP requests that it broadcasts to the DHCP VLAN, if
specified, or VLAN. You can specify the DHCP VLAN in the DHCP
Snooping Configure screen. See
.
Information
Select this to have the Switch add the system name to DHCP requests
that it broadcasts to the DHCP VLAN, if specified, or VLAN. You can
configure the system name in the General Setup screen. See
. You can specify the DHCP VLAN in the DHCP Snooping
Configure screen. See
.
Apply
Click Apply to save your changes to the Switch’s run-time memory.
The Switch loses these changes if it is turned off or loses power, so use
the Save link on the top navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Cancel
Click this to reset the values in this screen to their last-saved values.