P-971M User’s Guide

Chapter 6 Command Examples

56

Figure 21   

load_config Command Example 

CM> load_config 192.168.100.100 config.txt

6.2.2  run_app

Syntax: 

run_app

This command starts channel band scanning. This following figure shows an example. 

Figure 22   

run_app Command Example 

CM> run_app

Instance:  BFC System (0x80ffba50)

Running the system...

BcmCmDocsisStatusEventCodes::kCmIsNotOperational

Entering RemoveLeaseImpl:BcmShowNetworkTables exit
Non-Vol Settings successfully written to the device.
Scanning plan at 1 -- EIA -- 7000000 Hz...
Scanning plan at 1 -- EIA -- 681000000 Hz...

******************************************
            DOWNSTREAM STATUS
******************************************
  Tuner Frequency = 681000000 Hz
   Carrier Offset = 7 Hz
      Symbol rate = 5360537 sym/sec
              SNR = 40 dB
         QAM Mode = QAM256
        Tuner AGC = 0xfff00000
           IF AGC = 0x15124c08
      Power Level = 1 dB
              QAM = LOCKED
              FEC = LOCKED
******************************************
CM> 

6.2.3  ping 

Syntax:

ping <IpAddress>