![background image](/i/dell/161955/dell-c2665dnf/h/dell-c2665dnf-233.png)
Understanding the Printer Menus
231
IEEE 802.1x
NOTE:
IEEE 802.1x feature is available only when the printer is connected using Ethernet cable and it is available only when the
IEEE 802.1x authentication is enabled.
Purpose:
To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off and then on
again.
PS Data Format
Purpose:
To specify PostScript Level3 Compatible communication protocol for a parallel interface, you can configure the
PS
Data Format
settings for the wired network. The change becomes effective after the printer is turned off and then
on again.
Values:
Reset LAN
Purpose:
To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting
the printer, all wired network settings are reset to their default values.
Delete All Certificates
Purpose:
To delete all certificates of the printer. After executing this function and rebooting the printer, all certificates are
deleted.
Fax Settings
Use the
Fax Settings
menu to configure the basic fax settings.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
Fax Line Settings
Purpose:
To configure basic settings for the fax line.
Fax Number
Purpose:
To set the fax number of the printer, which will be printed on the header of a fax message.
NOTE:
Ensure to specify
Fax Number
before using
Junk Fax Setup
.
Auto
*
Used when auto-detecting the PostScript Level3 Compatible communication protocol.
Standard
Used when the communication protocol is in ASCII interface.
BCP
Used when the communication protocol is in binary format.
TBCP
Used when the communication protocol supports both ASCII and binary data to switch
between them according to the specified control code.
Binary
Used when no special processing is required for data.