![background image](/i/zelmer/154358/zelmer-27z012-27z011/h/zelmer-27z012-27z011-026.png)
28
Dear Clients!
Please read these instructions carefully. Pay your special
attention to important safety instructions. Keep this User’s
Guide for future reference.
Important proper handling instructions
Please read these instructions carefully before usage,
●
and keep it for future reference.
Place the toaster far from the table or bard edges. Make
●
sure that the surface is plain, clean and dry.
Remove all stickers and packing materials before first
●
operation.
Do not place on or near gas or electric burner or inside
●
the oven. Provide proper distance from the walls and
other flammable materials, such as clothes and curtains.
Minimum distance shall be 200 mm.
The bread can start burning; therefore it is not allowed
●
to operate the toaster near or under the curtains or other
flammable materials and it can not operate unattended.
The size of bread to be toasted shall be adjusted to the
●
toaster and not protrude over the bread inlet, it should
not be too thick neither too long, so that it does not block
the toast lift.
Never cover the appliance when it is plugged or hot.
●
Do not place cold toast inside bread inlets in order to
●
heat it, as it can block proper air- flow and cause the
appliance damage.
Do not operate on metal surface, i.e. metal sink.
●
Do not immerse any part of the toaster or supplying cord
●
and plug in water or other liquid in order to avoid electric
shock.
Do not move the toaster during operation or when it is hot.
●
Do not touch hot surfaces. Lift the toaster by side walls.
●
Do not leave unattended during operation.
●
Always remember to switch off the power and unplug
●
before removing, cleaning and storage as well as when
you do not use it.
Do not allow the crumbs accumulation at the toaster
●
bottom.
Keep the appliance clean. Follow the cleaning
●
recommendations of herewith User’s Guide.
Connect the iron to a suitable mains supply outlet
●
220-240 V, with grounding.
Unwind the supply cord completely before operation.
●
This appliance is not intended for use by persons
●
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
●
play with the appliance.
Do not allow the cord touch hot surfaces, rolled or hang
●
over the table or board edge.
The appliance is not intended to be operated by means
●
of an external timer or separate remote-control system.
If the non-detachable part of the cord is damaged,
it should be replaced by the producer or at a proper
service point or by a qualified person in order to avoid
any hazards.
The appliance can only be repaired by qualified service
personnel. Improper servicing may cause a serious
hazard to the user. In case of defects please contact
a qualified service center.
Use this appliance only for its intended use as described
●
in this manual. The appliance is intended for domestic
usage.
It is recommended to install RCD in order to provide
●
additional protection. The nominal value can not exceed
30 mA in electric circuit of given appliance. Contact
authorised electrician to obtain professional consulting.
REMARK! The toaster is an electronic appliance and
it neither operates nor can be blocked in toasting
position without connecting to mains supply outlet
220-240 V and switching power on.
Never use the appliancce layed on side. Never add any
additional substance to bread, do not butter it before
toasting it can result in electric shock or fire.
Specifications
The toaster technical parameters are included at the name
plate. The toaster is I class appliance, equipped with
supplying cord and plug with grounding.
ZELMER toaster meets the requirements of effective
standards.
The appliance meets the requirements of the following
directives:
Low Voltage Device (LVD) – 2006/95/EC.
–
Electro- Magnetic Compatibility (EMC) – 2004/108/EC.
–
The product is marked with CE symbol on the name plate.
Outline
(Fig. A)
1
Removable crumbs tray
2
Cold outsider walls
3
Special wide, deep self-centring inlets
4
Control panel:
a
One-side toasting button
b
Defrosting button
c
Re-heating button
d
Cancel or toasting button
5
Toasting time dial knob
6
Supply cord compartment
EN