Инструкция для ZYXEL ZyWALL 1100

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 9 Policy and Static Routes

ZyWALL 110/310/1100 Series User’s Guide

194

DSCP Code

Select a DSCP code point value of incoming packets to which this policy route applies
or select User Define to specify another DSCP code point. The lower the number the
higher the priority with the exception of 0 which is usually given only best-effort
treatment.

any means all DSCP value or no DSCP marker.

default means traffic with a DSCP value of 0. This is usually best effort traffic

The “af” choices stand for Assured Forwarding. The number following the “af”
identifies one of four classes and one of three drop preferences. See

Assured

Forwarding (AF) PHB for DiffServ on page 197

for more details.

User-Defined

DSCP Code

Use this field to specify a custom DSCP code point.

Schedule

Select a schedule to control when the policy route is active. none means the route is
active at all times if enabled.

Service

Select a service or service group to identify the type of traffic to which this policy route
applies.

Source Port

Select a service or service group to identify the source port of packets to which the
policy route applies.

Next-Hop

Type

Select Auto to have the ZyWALL use the routing table to find a next-hop and forward
the matched packets automatically.

Select Gateway to route the matched packets to the next-hop router or switch you
specified in the Gateway field. You have to set up the next-hop router or switch as a
HOST address object first.

Select VPN Tunnel to route the matched packets via the specified VPN tunnel.

Select Trunk to route the matched packets through the interfaces in the trunk group
based on the load balancing algorithm.

Select Interface to route the matched packets through the specified outgoing
interface to a gateway (which is connected to the interface).

Gateway

This field displays when you select Gateway in the Type field. Select a HOST address
object. The gateway is an immediate neighbor of your ZyWALL that will forward the
packet to the destination. The gateway must be a router or switch on the same
segment as your ZyWALL's interface(s).

VPN Tunnel

This field displays when you select VPN Tunnel in the Type field. Select a VPN tunnel
through which the packets are sent to the remote network that is connected to the
ZyWALL directly.

Auto Destination

Address

This field displays when you select VPN Tunnel in the Type field. Select this to have
the ZyWALL use the local network of the peer router that initiated an incoming dynamic
IPSec tunnel as the destination address of the policy.

Leave this cleared if you want to manually specify the destination address.

Trunk

This field displays when you select Trunk in the Type field. Select a trunk group to
have the ZyWALL send the packets via the interfaces in the group.

Interface

This field displays when you select Interface in the Type field. Select an interface to
have the ZyWALL send traffic that matches the policy route through the specified
interface.

Auto-Disable

This field displays when you select Interface or Trunk in the Type field. Select this to
have the ZyWALL automatically disable this policy route when the next hop’s
connection is down.

Table 68

Configuration > Network > Routing > Policy Route > Add/Edit (continued)

LABEL

DESCRIPTION