Инструкция для ZYXEL ZyWALL 1100

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 25 Bandwidth Management

ZyWALL 110/310/1100 Series User’s Guide

350

Connection and Packet Directions

Bandwidth management looks at the connection direction, that is from which interface the
connection was initiated and to which interface the connection is going.

A connection has outbound and inbound packet flows. The ZyWALL controls the bandwidth of traffic
of each flow as it is going out through an interface or VPN tunnel.

• The outbound traffic flows from the connection initiator to the connection responder.
• The inbound traffic flows from the connection responder to the connection initiator.

For example, a LAN1 to WAN connection is initiated from LAN1 and goes to the WAN.

• Outbound traffic goes from a LAN1 device to a WAN device. Bandwidth management is applied

before sending the packets out a WAN interface on the ZyWALL.

• Inbound traffic comes back from the WAN device to the LAN1 device. Bandwidth management is

applied before sending the traffic out a LAN1 interface.

Figure 229

LAN1

to WAN Connection and Packet Directions

Outbound and Inbound Bandwidth Limits

You can limit an application’s outbound or inbound bandwidth. This limit keeps the traffic from using
up too much of the out-going interface’s bandwidth. This way you can make sure there is bandwidth
for other applications. When you apply a bandwidth limit to outbound or inbound traffic, each
member of the out-going zone can send up to the limit. Take a LAN1 to WAN policy for example.

• Outbound traffic is limited to 200 kbps. The connection initiator is on the LAN1 so outbound

means the traffic traveling from the LAN1 to the WAN. Each of the WAN zone’s two interfaces can
send the limit of 200 kbps of traffic.

• Inbound traffic is limited to 500 kbs. The connection initiator is on the LAN1 so inbound means

the traffic traveling from the WAN to the LAN1.

Connection

BWM

Outbound

Inbound

LAN1