Chapter 28 Addresses
ZyWALL 110/310/1100 Series User’s Guide
387
28.2.2 IPv6 Address Add/Edit Screen
The Configuration > IPv6 Address Add/Edit screen allows you to create a new address or edit
an existing one. To access this screen, go to the Address screen (see
),
and click either the Add icon or an Edit icon in the IPv6 Address Configuration section.
Figure 253
IPv6 Address Configuration > Add/Edit
The following table describes the labels in this screen.
OK
Click OK to
save your changes back to the ZyWALL.
Cancel
Click Cancel to exit this screen without saving your changes.
Table 142
IPv4 Address Configuration > Add/Edit (continued)
LABEL
DESCRIPTION
Table 143
IPv6 Address Configuration > Add/Edit
LABEL
DESCRIPTION
Name
Type the name used to refer to the address. You may use 1-31 alphanumeric characters,
underscores(
_
), or dashes (-), but the first character cannot be a number. This value is
case-sensitive.
Object Type
Select the type of address you want to create. Choices are: HOST, RANGE, SUBNET,
INTERFACE IP, INTERFACE SUBNET, and INTERFACE GATEWAY.
Note: The ZyWALL automatically updates address objects that are based on an interface’s
IP address, subnet, or gateway if the interface’s IP address settings change. For
example, if you change 1’s IP address, the ZyWALL automatically updates the
corresponding interface-based, LAN subnet address object.
IPv6 Address
This field is only available if the Address Type is HOST. This field cannot be blank. Enter
the IP address that this address object represents.
IPv6 Starting
Address
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the beginning of the range of IP addresses that this address object represents.
IPv6 Ending
Address
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the end of the range of IP address that this address object represents.
IPv6 Address
Prefix
This field is only available if the Address Type is SUBNET. This field cannot be blank.
Enter the IPv6 address prefix that the ZyWALL uses for the LAN IPv6 address.
Interface
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the
Address Type, use this field to select the interface of the network that this address object
represents.
IPv6 Address
Type
Select whether the IPv6 address is a link-local IP address (LINK LOCAL), static IP
address (STATIC), an IPv6 StateLess Address Auto Configuration IP address (SLAAC), or
is obtained from a DHCPv6 server (DHCPv6).
OK
Click OK to
save your changes back to the ZyWALL.
Cancel
Click Cancel to exit this screen without saving your changes.