![background image](/i/bmw/160195/bmw-c1-2001/h/bmw-c1-2001-125.png)
11.49
•
Add 0.45 mm (0.0177 in) to both measurement
results and the thickness of the gasket (com-
pressed)
•
Check installed width of crankshaft
•
Allow for thickness of thrust washers
Adjusting data:
Crankshaft end float ............................0.2…0.4 mm
................................................ (0.0079…0.0157 in)
•
Correct by changing thickness of washer in
drive-side half of crankcase
Joining halves of crankcase
e
Attention:
Make sure that all bearings of crankshaft are ade-
quately lubricated!
•
Working from the inside toward the outside,
tighten securing bolts in a cross sequence
•
Replace copper seal (arrow)
•
Turn crankshaft through several complete revo-
lutions and check freedom of movement
C1111170
C1111180