![background image](/i/bmw/160195/bmw-c1-2001/h/bmw-c1-2001-133.png)
12.7
12 41 020
Replacing starter
e
Attention:
Disconnect ground cable from battery and insulate
it!
•
Remove intake-air plenum chamber from rear
mudguard
•
Remove fasteners securing rear mudguard
•
Unsnap discharge hose from plenum chamber
on auxiliary swing arm
•
Remove the fasteners securing the air filter hous-
ing to the powertrain cradle
•
Detach positive and negative cables (arrows)
from starter
•
Press plenum chamber up and to the right, then
pull the rear mudguard cover over the starter
•
Pull the starter out of the guide
L
Note:
Grease pinion before installing, oil o-ring!
Fluids and lubricants:
Starter pinion......................................... Shell HDX2
X
Torque specification:
Starter to engine .......................................... 10
Nm
12 11 070
Replacing alternator
–
Removing ignition trigger cover
a
....................................................See Group 11
•
Remove fasteners (arrows)
•
Remove bolts (1) and take out alternator
When installing:
•
Installation is the reverse of the removal proce-
dure
X
Torque specification:
Alternator bolts............................................. 10 Nm
Cable attachments (Tapite bolts)
(+ Loctite 243) ................................................ 6 Nm
C1120060
C1110190
1