![background image](/i/bmw/160195/bmw-c1-2001/h/bmw-c1-2001-453.png)
72.5
Replacing Bowden cable with belt
buckles on left/right
L
Note:
Belt buckles and Bowden cables cannot be re-
placed individually
–
Open the seat
–
Remove instrument trim
–
Remove top tunnel panel
–
Remove left and right service covers
–
Remove left and right rear side trim panels
a
....................................................See Group 46
•
Loosen top, left and right tunnel panels
•
Removing central belt release mechanism
•
Undo cable tie (arrow)
•
Disconnect plug connection for seat-belt switch
•
Detach left/right belt buckle (arrow)
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
e
Attention:
When installing, make sure that the Bowden cable
and the cable are correctly routed.
Make sure that the Bowden cables are free of kinks.
Additional information for right buckle do not crimp
or damage safety belt!
•
Check operation of central belt release mecha-
nism
X
Torque specification:
Belt buckle attachment ................................ 42 Nm
Replacing indicator switches for seat
belt
L
Note:
The control switches are an integral component of
the belt buckles and cannot be replaced separately,
replace belt buckle as necessary
C1720010
C1720020